Dennis H
Member
I am having trouble mapping the SB and SC switches to the AUX 2 and AUX 4 in my Skookum 720 software. I want these switches to control the GPS functions 1 & 2 in the Skookum GPS.
One issue, some areas list the 14SG switches 1-12, and the book refers to them as 2 letter acronyms. Unless all start with "S", then A, B, C, D, etc., unless you are supposed to refer them to 1, 2, 3, 4, etc. or S1, S2, S3, S4, etc.,
Not trying to confuse anyone, I am just wanting to map the SB and SC to Aux 2 & 4 in the Skookum GPS Software Control Panel.
I am using the 7008 Futaba receiver linked to the Skookum 720 via 1 SBUS cable. (one cable-Fasttest mode) All functions are working fine, just need to get the switches mapped, and I should be ready for flight testing.
I believe I am close, but not there as of this post.
Thanks, Dennis
One issue, some areas list the 14SG switches 1-12, and the book refers to them as 2 letter acronyms. Unless all start with "S", then A, B, C, D, etc., unless you are supposed to refer them to 1, 2, 3, 4, etc. or S1, S2, S3, S4, etc.,
Not trying to confuse anyone, I am just wanting to map the SB and SC to Aux 2 & 4 in the Skookum GPS Software Control Panel.
I am using the 7008 Futaba receiver linked to the Skookum 720 via 1 SBUS cable. (one cable-Fasttest mode) All functions are working fine, just need to get the switches mapped, and I should be ready for flight testing.
I believe I am close, but not there as of this post.
Thanks, Dennis