trainrider06
Active Member
Ok I reset my BeastX, went through and set it back up binding it to my DX8...Now it initializes or acts like it is
But doesn't....no throttle no spool up, servos all work fine....do I need to do the ol throttle full after first couple beeps and drop it back down??
Also on my DX6i that it was bound to, the throttle wouldn't come on line unless I switched on throttle hold then off. Never did know why it did that but that was how I always had to get it to fully initialise...yep already tried that with the DX8....
I have a Castle 75a esc by the way, also noticed that when the lights are flashing through sequence (the yellow ones) that the N light lingers for a few seconds on then goes off...if it did this before I never noticed it...
But doesn't....no throttle no spool up, servos all work fine....do I need to do the ol throttle full after first couple beeps and drop it back down??
Also on my DX6i that it was bound to, the throttle wouldn't come on line unless I switched on throttle hold then off. Never did know why it did that but that was how I always had to get it to fully initialise...yep already tried that with the DX8....
I have a Castle 75a esc by the way, also noticed that when the lights are flashing through sequence (the yellow ones) that the N light lingers for a few seconds on then goes off...if it did this before I never noticed it...