I have a AOMWAY FPV 5.8G 8CH 200mW AV Transmitter Integrated 700TVL CMOS HD Camera and it is my first attempt to wire anything fpv. Of course I'm going to hit a road block. I have no idea how to power the camera from my Naze32 Rev6 control board. On the website the transmitter is rated at 7-24V, but upon receiving the product the transmitter says it's rated 6-24V, with an output of 5V to the Camera. I have a cell checker/beeper connected to the battery, so I was thinking of just plugging the transmitter into an extra motor slot on the control board, but that only supplies 5V from what the diagrams say. Is 1-2 volt below to low? What would you do?