In this video we go through and set up the suspension on the truck. This includes Ride Height, Camber and Toe In. Caster is where the manual told us to put it and is adjusted via the clips in the upper control arms.
It has been a long time coming, but lets get the AlZRC 380 motor installed as well as the Hobbywing 60 amp esc and the Ikon2 gyro mounted!
3M Double Sided Tape
https://amzn.to/2KX2tvP
Hobbywing 60 Amp ESC
https://amzn.to/2ISqstG
Ikon2 Flybarless Controller
https://amzn.to/2Du4kC9
You know we are getting close when we install the engine into the chassis and set the gear mesh. In this video, not only do we install the engine and set the mesh, but we also replace that metal spur gear with a plastic spur gear, replace the clutch bell that the metal spur chewed up, but we...
engine install
engine installation
fuel tank install
fuel tank installation
howto
muffler install
muffler installation
nitro rc
rchelp dotcom
rchelpdotcom
setting gear mesh
setting gear mesh tmaxx
setting gear mesh traxxas
t maxx
t maxx 2.5
t maxx build
t maxx clutch
t maxx clutch bell
t maxx clutch bell problem
t maxx clutch upgrade
t maxx nitro
t maxx slipper clutch
t maxx spur gear replacement
tmaxx
traxxas t-maxx 2.5
It's time to install the servos on the Goblin 380! We already did this in a live stream, but I'm not going to make everyone sit through over 10 hours of video just to see me install some servos. We we are redoing everything on this helicopter and going step by step. let me know if you have any...
build video
cyclic
howto
install
installation
rchelp dotcom
rchelpdotcom
sab goblin 380
sab goblin 380 build
sab goblin 380 review
sab heli division
servo
servo tester
set up
setup
tail
Hey Fellas, I am in the process of building a power supply like those sweet ones in some other threads and I have a question. I would like to use a cool toggle switch to power up the two PS units when I use them so I can just leave it plugged up on my bench all the time, is there a good way...
Hello everyone. I have been asked time and time again to do videos on how to work the settings on the DX6i. Well, I have done just that. I kinda got sidetracked with it though in doing the customizations to mine, but I plan on doing more. If you would like to see something on video, just let me...