problem

  1. S

    Cars Unique Issue with HobbyWing Max10 SCT 120A - Not the same as all the other issues

    I have a truggy bought only 3 months ago with a HobbyWing WP MAX10 SCT RTR 120A. Lightly used, not in dirt or water without any problems for the first 3 months. An issue occurred the other day. I took it out and drove it for 1 minute about 200 meters then the following issue occurred: Every...
  2. M

    Cars Tamiya Cc-01 Not Working

    Hi! I'm having a problem with my first non rtr modell, tamiya cc01. I built it 6 hours ago, but its not working properly. If i pull a Full throttle on the transmitter , the modell starts revving, but if i press the throttle slowly, it starts moving, but i hear grinding noise i checked the...
  3. graywolf71

    Trucks Truck Runs Forward When You Turn It On

    I have a problem with my Planet Toys Nissan truck. Recently I went to run it, and every time I turned it on it ran in reverse for half a second, then was stuck running forward, both with and without the controller on. You can still reverse it with the controller, but as soon as you let off it...
  4. chevell69

    Other DX5e servo revercing switches

    I have a used DX5e and it has intmenting problem with the SERVO REVERCING SWITCH SOME TIMES IT WILL WORK SOME TIMES IT WONT I HAVE A FEELING THAT IT COULD BE A COLD SOLDER JOINT OR A SWITCH THAT IS GOING BAD OR JUST NEEDS TO BE BLOWN CLEAN
  5. pavotibio

    Spektrum DX8 Idle Up Switch

    Hi Guys. It´s been a while. Guess the first year after becoming a parent leaves you little time to do anything else, uh? Anyways. I accidentally broke the idle up switch on my DX8, bought the spare part (on-off-on) and replaced it. I took a picture of the wiring color code to not make any...
  6. krayon

    Micro Blade nano cpx shunt down suddenly

    Hi everyone, Sometimes when i fly with the nano cpx, the heli shunt down suddenly and fall... Is not a motor problem because the blue led also turn off... Have anyone an idea ? Regards. Krayon
  7. F

    450 Is this looking ok for you?

    Hi guys. Thank god I found rc-help on Youtube and this fine forum! Since 2011 I'm building my HK450 V2. It's not finished yet :tan:. But I just powered it up the first time. Can you have a look at Does it look ok for you? Or do you see a tail shaking, too?
  8. J

    Micro *****mcpx lack of power issue***** please help!!!!

    Hello, Wondering if you guys can help. So far no one else has been able to. I have an mcpx v2. Almost all vertical thrust is gone. At full stick it is just enough to hover. I already replaced the main motor, tail motor, 3in1 board, blades, main gear, tail rotor, feathering shaft, batteries...
Top Bottom