Nothing works to arm/initialize my new castle phoenix edge 100 esc. I made sure the settings via the Castle link are correct on the computer. They are set for throttle: auto calibrate endpoint and the other is fixed endpoint. I have tried both settings with no luck. All the other settings I left at default factory settings. I am using a spectrum receiver Ar9020 with 2 satellites and DX9 tx. Some of the things I have tried are first to make sure I am in a linear throttle curve 0,25,50,75,100. Per the instructions of the esc all that was needed was to bind my receiver, put the throttle at mid position and eventually lower to 0 throttle. All I hear is the original first esc beep, then the battery cell count and nothing else after that. I also tried to change to fixed endpoint and set my tx throttle servo setting to 30 for up and down positions. Then I plugged in the esc and with throttle at high increased the servo throttle setting to 100 and above all the way to 130 with no beep from the esc. I also tried the low servo setting from 30 and increased it to above 100 also with no beep. I also tried changing my trims to -100 but with no initialization of the esc. The last thing I did was use a new Ar9020 receiver but also with no luck getting this esc to initialize/arm.
The videos I've seen show the old adjust for throttle endpoints such as I used on my 2 Talon 90 esc's. Which is as I described above with no luck. What do I need to do for this Edge 100 to initialize/arm? Have run out of ideas.
The videos I've seen show the old adjust for throttle endpoints such as I used on my 2 Talon 90 esc's. Which is as I described above with no luck. What do I need to do for this Edge 100 to initialize/arm? Have run out of ideas.