daved20319
New Member
I just reflashed my Turnigy 9x with OpenTX FW, went through the basic setup, plugged in the Phoenix USB cable, the TX powered up normally with the switch off, but Phoenix said my TX wasn't connected. Tried pulling the module, no joy, then decided to try powering up the radio. BINGO! This has been my biggest issue with Phoenix/TX, sometimes it sees my radio with the module in, sometimes I have to remove the module, and now it requires that the power switch be on after switching to OpenTX.
So, is this just how it's going to be, or is there some setting I can change in the program or TX to fix it? Thanks.
Dave
So, is this just how it's going to be, or is there some setting I can change in the program or TX to fix it? Thanks.
Dave