THOMAS KING
New Member
I have been working on both my 600 and 700 and seem to have the same problem with them on the 600 i am using the align 780 gyro on the 700 using the G401 but while i was hovering the 700 in HH mode i was at two feet off the ground holding hover reduced throttle it went into a left hand spin (thats tail left nose right) and ripped off the tail, so i went back to my 600 and got it setup both in rate mode and HH mode i have pos 1 set at -55 rate, pos 2 at +75 HH and pos 3 - 55 rate. While flying sat i set this up on a training pod so as to have it off the ground while hovering it was holding fine i had to hold a little right rudder to comp for tork but was'nt bad but as soon as dropped throttle it too went into a left hand spin, i was in pos 1 at -55 rate. it seems that on rate the tail will always center but in HH mode it will move very slow and stay on the right or let side and put me in the same spin so not sure what to do. Confused!!! Open for all suggestions Thanks Much