Rc-Help Trainer Build Part 6, Installing the Motor, Control Horns & Servos

[Tony]

FINALLY we are installing some electronics. In this video I start out by showing you how I mount my motor to the nose of this plane. The we move onto installing the Dubro control horns that I used on the last trainer with great success. Finally I show you how to install the servos into the fuse. It's a pretty basic video, but there are some points that needed to be touched on and I think I did just that.

Let me know what you think.
http://youtu.be/dlvq_whpTzg

 

[Adam]

Hey tony one question on mounting the motor do we have to put washers on one side of the motor mount to give it an angle since the nose is square and if so what sideand how much angle.

 

[Tony]

The plans already have down angle built into them. if you remember back in the fuselage build video, I had said you can either make the plans with right angle, or you could use washers. I myself opted to use washers.

If this is the way you want to go, then put the washers on the left side to angle the motor to the right. You only want about 3 degrees of right angle though.