Boogs
Member
After 10 flights my Blade 300 X has developed a vibration. I pulled the (new/stock) motor, cleaned up the shaft with rubbing alcohol and did the red loctite routine. Replaced the main bearings with Boca's and installed the Lynx frame stiffener. And just for good measure I took the tail blade grips apart, cleaned and put in fresh grease. Cleaned the tail shaft and lubed with Dry Fluid, same on the new main shaft, new swash plate.
Now just waiting until tomorrow to see if the vibration is gone. If not, I might use it to sight in my 7mm Weatherby Magnum
Now just waiting until tomorrow to see if the vibration is gone. If not, I might use it to sight in my 7mm Weatherby Magnum
