Reply to thread

Message

<blockquote data-quote="Tony" data-source="post: 181907" data-attributes="member: 1">Just over 2 years ago was my last post in this thread and I just happened over this thread when I saw the box with the S6 charger in it that is still on the shelf and has still not been used. That is when I saw the STL file that I uploaded here and no matter what I did with that file, I could not get it to successfully print to save my life. So today I pulled the file that I have all but forgot about and decided to print it. I had thought I had an issue with the file. Something had to be wrong I thought. So I loaded it up into my slicer, removed most of the basic print and just printed the center section that holds the charger. It's in my printer now and is printing, what looks like, perfectly. This is the test print to see if the charger fits and if it does, I think I may just have to finish this charger case. So far, I have only had one failed print on my new printer and that was a quad hanger that was way too small, I didn't do bed leveling and I was using filament that was older than dirt and dusty as all get out. If anyone is needing anything printed, hit me up by sending me a pm (conversation) and we will make it happen. Hopefully I don't forget about this charger again and I have an update to this post soon.</blockquote>

[QUOTE="Tony, post: 181907, member: 1"] Just over 2 years ago was my last post in this thread and I just happened over this thread when I saw the box with the S6 charger in it that is still on the shelf and has still not been used. That is when I saw the STL file that I uploaded here and no matter what I did with that file, I could not get it to successfully print to save my life. So today I pulled the file that I have all but forgot about and decided to print it. I had thought I had an issue with the file. Something had to be wrong I thought. So I loaded it up into my slicer, removed most of the basic print and just printed the center section that holds the charger. It's in my printer now and is printing, what looks like, perfectly. This is the test print to see if the charger fits and if it does, I think I may just have to finish this charger case. So far, I have only had one failed print on my new printer and that was a quad hanger that was way too small, I didn't do bed leveling and I was using filament that was older than dirt and dusty as all get out. If anyone is needing anything printed, hit me up by sending me a pm (conversation) and we will make it happen. Hopefully I don't forget about this charger again and I have an update to this post soon. [/QUOTE]

Verification