precociousmouse
Member
Hey all
So I have been flying my diatone et200 based quad around by eye for a little while now but am looking to fit my quanum v1 fpv setup onboard. Rather than add in another lipo to the frame, I was considering directly soldering a connector to the pdb and powering it off that.
On that thought, I was considering taking a JST connector off the same pads that the current lipo connects to as it is reading out at 8.3v - has anyone else done this or would recommend for/against this?
cheers!
So I have been flying my diatone et200 based quad around by eye for a little while now but am looking to fit my quanum v1 fpv setup onboard. Rather than add in another lipo to the frame, I was considering directly soldering a connector to the pdb and powering it off that.
On that thought, I was considering taking a JST connector off the same pads that the current lipo connects to as it is reading out at 8.3v - has anyone else done this or would recommend for/against this?
cheers!