Im stumped, I flew this two years back, with my son. Then it was set aside as every thing was after we Lost him. I know it flies. The thing is I remember that I had to reverse one of the settings on the radio, and I don't remember which one it is. I am using a DX8. I put the battery in the t380 quad and it goes through the beeps as its ready to fly, but it wont. I had this problem the first time I got it, then found out about reversing the switch. I just cant remember which one. I guess my age is catching up with me. I tried setting it up like the 350 blade, no go. Oh well had to try. Thanks for any help.
Quad lotus t380 set up help
- Thread starter kason
- Start date
EyeStation
Well-Known Member
Did you try to re-bind it to the transmitter? Sometimes that's all it takes if you haven't changed any settings.
Inside the TX settings might be a Throttle Reverse setting that might keep it from spooling up.
Other than that, only switch I could see effecting you would be the throttle Hold switch.
Inside the TX settings might be a Throttle Reverse setting that might keep it from spooling up.
Other than that, only switch I could see effecting you would be the throttle Hold switch.
Lee
Well-Known Member
I found the manual. http://www.himodel.com/manual/T380_quakcopter.pdf
It doesn't say anything about arming the board with stick position.
Just plug the battery in and go.
Don't know if you have the manual, so you can check the settings against what it says in here.
It doesn't say anything about arming the board with stick position.
Just plug the battery in and go.
Don't know if you have the manual, so you can check the settings against what it says in here.
I do appreciate you looking that up for me. I am going to try what has been suggested, and go by the manual. Ill post later if I have any luck. Thanks for your help. My radio tray arrived today from Hobby King. I have to say Im disappointed. It came without any screws to put it together with. Shame on Hobby King.
I would however the tray wont work well with a DX8 radio either. So IM going to redesign the whole thing to do what I need, by the time Im done it wont be close to what they sent anyways. We all know how soft the screws are anyways, a little to tight and they break or strip. The clamp on the bar I needed to tighten to get it to hold, IT broke LOL . I should have ben smart looked at the pic. and made my own from the beginning. That's why I have a cnc machine. I was just lazy and I paid for it.