Lee Well-Known Member Oct 11, 2014 #1 Went to fly the Warp today, and the RX sat was dead? Did a re bind and all seemed good to go. But on spool up, there was no soft start, and once in the air, the Gov settings were wrong??? BIZARRE!!!!!
Went to fly the Warp today, and the RX sat was dead? Did a re bind and all seemed good to go. But on spool up, there was no soft start, and once in the air, the Gov settings were wrong??? BIZARRE!!!!!
F Formosaflier New Member Feb 13, 2015 #4 I noticed that when I use My Turnigy 9X with FSM sim the settings disappear
R RMB677 Member Feb 15, 2015 #5 Had that happen when I neglected to shut off my DX6i and it ran down to nothing. Lucky that I had my setting recorded.
Had that happen when I neglected to shut off my DX6i and it ran down to nothing. Lucky that I had my setting recorded.
murankar Staff member Feb 15, 2015 #6 If you do the setup on the PC its a matter of retransmitting the settings back over. Sent from my LG-E980 using Forum Runner
If you do the setup on the PC its a matter of retransmitting the settings back over. Sent from my LG-E980 using Forum Runner