DIY Syma X5C revive

bigone5500

bigone5500

Well-Known Member
A coworker gave me this X5C that had one motor not working. He crashed it and I assume the FC probably had a burned out ESC. I stripped it down and kept the motor assemblies and blades.

I want to install a cheap FC but don't know the current draw from these motors. Can I assume 10A to be sufficient? These motors are 20mm L x 7mm D. The wires are super thin and appear to be around 22 or 24ga. maybe even smaller.

20210307_091817.jpg20210307_092550.jpg
 
These are brushed motors and don't last all that long. Have you swapped the wires around to test the motors?

As for FC or ESC, that is a tough one with these motors. Most have a built in ESC in the board, since they are such a simple ESC.

Here is a link to the manual - http://www.symatoys.com/upload/201809/04/201809041536445148.pdf

I don't see an ESC, but I do see the the receiver board, x5c-10. I may actually have a quad with these motors and the receiver board if you need it. I will just need to get out to the barn to verify...
 
Top Bottom