FBL Gyro Tgz380 3 Axis Gyro

[Baz Gascoigne]

trying to setup setting G on a
TGZ380 3 Axis Gyro
servo centering every time i trim them save settings they return back to the same position is this right

 

[murankar]

Its been a few years since I set up a beastx . If I remember correctly what happens is the servos while programming will be center; but once you save the settings they go to the stick positions.

 

[Tony]

If it helps, my videos on the AR7200BX will cover the setup of that gyro. It's pretty much exactly the same.

AR7200BX Gyro | Rc-Help Forum