Reply to thread

Message

<blockquote data-quote="Tony" data-source="post: 150374" data-attributes="member: 1">Today I went out in the studio and ACTUALLY cleaned off the work bench. Then, I shot a blog video that I will be uploading very soon regarding Ad Blockers. This I feel needed to be addressed. Finally, I shot the video on setting up the Ikon2. This is a very basic setup video. I did not show how to reprogram the switches or the channels on my DX9, that will be in a later video. I also did not show the helicopter or pitch gauge when setting up the tail or the head. I have covered these in many videos. But at the end of the video I did say that if people wanted these videos specifically on the Ikon2, I would go back out there and make it. It was just getting too hot out there and the wasps were getting pretty bad. I may just end up reshooting that video because of some of the things that happened during the video. For example, I changed the servo for the tail, but forgot that this new servo is 760 and not 1520. I damn near burnt up that servo... And my cyclic pitch is different one way than it is the other, and you adjust them together. This even though I was at 0º of pitch. Not sure what is going on there... Time to start editing...</blockquote>

[QUOTE="Tony, post: 150374, member: 1"] Today I went out in the studio and ACTUALLY cleaned off the work bench. Then, I shot a blog video that I will be uploading very soon regarding Ad Blockers. This I feel needed to be addressed. Finally, I shot the video on setting up the Ikon2. This is a very basic setup video. I did not show how to reprogram the switches or the channels on my DX9, that will be in a later video. I also did not show the helicopter or pitch gauge when setting up the tail or the head. I have covered these in many videos. But at the end of the video I did say that if people wanted these videos specifically on the Ikon2, I would go back out there and make it. It was just getting too hot out there and the wasps were getting pretty bad. I may just end up reshooting that video because of some of the things that happened during the video. For example, I changed the servo for the tail, but forgot that this new servo is 760 and not 1520. I damn near burnt up that servo... And my cyclic pitch is different one way than it is the other, and you adjust them together. This even though I was at 0º of pitch. Not sure what is going on there... Time to start editing... [/QUOTE]

Verification