Reply to thread

Message: <blockquote data-quote="Rob Lancaster" data-source="post: 168042" data-attributes="member: 6154">Ok; the tubing bender has been completed and tested and it did a great job! First time out!!Photo 1762 just shows the handle, rollers and compression lid in the storage position...Photo 1763 shows the handle in the bender mode.. Take a close look, you'll see.... At first this kind of thing twisted my mind. But Photo 1763  shows the way you want to do the actual set up for a great bend..  The aluminum stock is 3/8 OD thick wall extruded tubing.  Very ridged stuff.. No pinching or pulling that causes cracks.. Super nice!!!  Hopefully we can get that mm precision we're after...</blockquote>