Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Welcome To Rc-Help.com
RC-Help Lounge
What Did You Do Today???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RandyDSok" data-source="post: 168597" data-attributes="member: 201"><p>I'm not sure that coffee is all you actually need... LMAO</p><p></p><p>The contact pads I was referring too... can only be reached if you remove the board and I clean both sides of them. There are 3-4 leads/pads going to the motor and the pads those connect with... then there is group of contacts and pads ( probably between 10-12 on each side, so 20-24 or so total ) that are used to connect the outer controller board to the inner electronics. Then in addition, I'll also clean the SATA and power connectors while I'm at it.</p></blockquote><p></p>
[QUOTE="RandyDSok, post: 168597, member: 201"] I'm not sure that coffee is all you actually need... LMAO The contact pads I was referring too... can only be reached if you remove the board and I clean both sides of them. There are 3-4 leads/pads going to the motor and the pads those connect with... then there is group of contacts and pads ( probably between 10-12 on each side, so 20-24 or so total ) that are used to connect the outer controller board to the inner electronics. Then in addition, I'll also clean the SATA and power connectors while I'm at it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Welcome To Rc-Help.com
RC-Help Lounge
What Did You Do Today???
Top
Bottom
