Reply to thread

Message: <blockquote data-quote="LooseNut" data-source="post: 178518" data-attributes="member: 8765">Played with the AR636 Heli a little bit, Tinkered with the 450 for my brother, getting ready to wrap it up. Got my goodies from Online metals restocking my shaft making material, 5mm and 8mm diameter. Just in case I need it.I started laying out a set of Skids for my 450 Pro. I see a lot of the newer Heli's with an angle to them lifting the rear a bit higher. Is there a favored Angle? Or is it just a TLAR thing? I'm going to 3D print them up with the Proto-Pasta CF HTPLA and see how it holds up. I have  NylonX CF filament as well to run once I get it sorted out, takes a little tinkering to dial in but it makes some great parts.</blockquote>