Hi All,
New to the forum and new to RC helicopters.
I have a little Blade 120 S2 which I am just getting used to tail in hover and absolutely love it.
All my reading and video watching tells me ideally I should be learning on something a bit bigger and be collective pitch.
So inpatient me went out and brought a Align Trex 450l. To get to the point the build went fine and time to wire it up.
Ahh, alot more complex that a RC car, but with the help of the manual and a few google searches I finally got there.
The issue I have is when I powered it up and binded the receiver all the servos go to full right (not the tail servo, motor is not connected) and stay there, and therer doesn't appear to he any response from the radio sticks, though I powered down pretty quick to avoid damaging the servos. But it happens every startup.
A orange light on the gyro runs back and forth (probably asking to be set up) I have no idea what to do about it.
Radio settings are normal swash, all servos at 100%, all trims at 0.
Any guidance would be greatly appreciated.
I have:
Align Trex 450l Super Combo 6S
- RCE-BL45P ESC
- RCM-BL460MX Motor
- Microbeast Plus Gyro
Spektrum NX6 Radio
Spektrum AR8020T Receiver
Sorry post is so long, just tried to give as much info as possible.
New to the forum and new to RC helicopters.
I have a little Blade 120 S2 which I am just getting used to tail in hover and absolutely love it.
All my reading and video watching tells me ideally I should be learning on something a bit bigger and be collective pitch.
So inpatient me went out and brought a Align Trex 450l. To get to the point the build went fine and time to wire it up.
Ahh, alot more complex that a RC car, but with the help of the manual and a few google searches I finally got there.
The issue I have is when I powered it up and binded the receiver all the servos go to full right (not the tail servo, motor is not connected) and stay there, and therer doesn't appear to he any response from the radio sticks, though I powered down pretty quick to avoid damaging the servos. But it happens every startup.
A orange light on the gyro runs back and forth (probably asking to be set up) I have no idea what to do about it.
Radio settings are normal swash, all servos at 100%, all trims at 0.
Any guidance would be greatly appreciated.
I have:
Align Trex 450l Super Combo 6S
- RCE-BL45P ESC
- RCM-BL460MX Motor
- Microbeast Plus Gyro
Spektrum NX6 Radio
Spektrum AR8020T Receiver
Sorry post is so long, just tried to give as much info as possible.