I just upgraded to the new DX9 transmitter and wanted to get back to practicing on the sim but had problems at first. Found out that first off there is not a DX9 available on the pull down menus for tx. Thus I needed to create a custom which I named DX9. I then discovered that I needed to create in my DX9 a model called Phoenix with no changes to any swash or settings used to fine tune setup a RC heli. I make sure this is the model that would come on when my tx is turned on. Once this was done I then did all the needed calibration in the Phoenix software for this tx which I had custom made in the transmitter area of the Phoenix. This will begin once I plug in my cable from the computer to the DX9 and it turns on. Now the sticks work correctly for throttle, rudder, pitch and aileron. Hope this helps.