Quad New Frame

D.O.G.

Goblin 380 Supporter
I ended up getting a 4" TBS open source podracer drone frame this week. It's going use 1806/2700Kv motors. It should move along very briskly lol batch_IMG_0861.JPG
 

Tony

Staff member
Looks like a nice frame. I know this is an old thread, but have you built it yet and flown it? (may have, just now getting through the posts)
 

D.O.G.

Goblin 380 Supporter
What's up Tony. I haven't flown it yet because I haven't finished it :(. I'm kind of stuck. I'm using FC and 4in1 that I had laying around. There not the right electronics to have in it but so far they fit fine. The motors fit too with a little adjusting. Where I'm stuck at is the Littlebee 20a 4in1. I'm not sure how this wiring will go with my Omnibus F4 V2 and the 4in1. I never used or wired up any 4in1 before. I'm so confused.
 

D.O.G.

Goblin 380 Supporter
What's up Tony. I haven't flown it yet because I haven't finished it :(. I'm kind of stuck. I'm using FC and 4in1 that I had laying around. There not the right electronics to have in it but so far they fit fine. The motors fit too with a little adjusting. Where I'm stuck at is the Littlebee 20a 4in1. I'm not sure how this wiring will go with my Omnibus F4 V2 and the 4in1. I never used or wired up any 4in1 before. I'm so confused.

Oh yeah. I can't find a FVT LittleBee 20a 4in1 esc Schematics on it. This esc is discontinued :(. I know it can be done but not by me so far :(.
 

Tony

Staff member
If I can remember correctly (forgive me, it's been quite a while lol), the S1, S2, S3 S4 is your motors. These will go to the signal pins on the FC marked PWM1, PWM2, PWM3, PWM4. It will be using a common ground and power, so those can come from the 4-1 and go to any positive and negative pin on the board, I would just wire these to the PWM1 slot.
 

D.O.G.

Goblin 380 Supporter
Thanks again Tony :). I give that a try. Another question, does blheli suite work with a 4 in1 to change motor and direction? I probably can wait to find out once I get everything working :). but I figure you might know in advance lol :).
 

Tony

Staff member
I'm not sure if blheli will work on that one, but worth a try when you get it working.
 

D.O.G.

Goblin 380 Supporter
Alrighty now Mr Tony. All system go. Now to do the fine tune adjusting, get everything calibrated and working like it should. Thanks again Tony for your the man :notworthy:
 

D.O.G.

Goblin 380 Supporter
It's my pleasure Ivan! I'm surprised I remembered that stuff. lol.

See, your not that old. You still remember not like I and get that sometimezheimer disease every once in awhile Lol :). BTW, if anyone wants to know, BLHeli suite does work on that 4in1.
 

D.O.G.

Goblin 380 Supporter
Update on the 4" TBS pod racer. With Tony's help, I'm almost ready for a flight :). I'm waiting on FPV camera and batteries to come in. Then I can connect the vtx and camera. After that, the pod is ready to boggie :) batch_IMG_0897.JPG I think it might be under 250g
 
Top Bottom