Tasajara
Active Member
Well I got a fun Jet a while back and thought I would do a build thread on my Build...
I will be glassing and adding a few extra things on my build. It want be a stock setup.
So here is a list of the parts I am using.
Turnigy SK3 Fandrive - 3659-1900kv (90mm EDF)
Yes an edf motor turning a prop... the reason was it is rated for 1770 watts but with good cooling it will be pushing more like 2000+.
Hobbyking SS Series 190-200A ESC
I should be pulling in the 100 to 120amp range.
Corona DS939HV Digital Metal Gear Servo 2.8kg/ 12.5g/ 0.12sec
These servos seem to work very well and seem to be pretty strong for what I am doing.
I will be using a Castle Creations Switching BEC
That way I can adjust he voltage a little higher for my digital servos to 7.2 volts giving them a little more torque.
Thunder Power G6 2700mAh Pro Power 6S 22.2V 65C Lipo Pack I wanted to spend a little extra
and get a battery I know would last and handle the power I would be pushing...
Aeronaut Propellers CAM Electric 7x7
But for my maiden I will use a 6x6 Graupner Cam prop to check temps on my power system. Don't want to push it to hard till I get use to flying it
and get it all trimmed in.
I will be replacing the stock motor mount for this one....Motor Mount w/Screws: FunJet ULTRA
The metal mount will be much stronger and also act as a heat sink for the motor.
Here are a few pics of my parts..
I will be glassing and adding a few extra things on my build. It want be a stock setup.
So here is a list of the parts I am using.
Turnigy SK3 Fandrive - 3659-1900kv (90mm EDF)
Yes an edf motor turning a prop... the reason was it is rated for 1770 watts but with good cooling it will be pushing more like 2000+.
Hobbyking SS Series 190-200A ESC
I should be pulling in the 100 to 120amp range.
Corona DS939HV Digital Metal Gear Servo 2.8kg/ 12.5g/ 0.12sec
These servos seem to work very well and seem to be pretty strong for what I am doing.
I will be using a Castle Creations Switching BEC
That way I can adjust he voltage a little higher for my digital servos to 7.2 volts giving them a little more torque.
Thunder Power G6 2700mAh Pro Power 6S 22.2V 65C Lipo Pack I wanted to spend a little extra
and get a battery I know would last and handle the power I would be pushing...
Aeronaut Propellers CAM Electric 7x7
But for my maiden I will use a 6x6 Graupner Cam prop to check temps on my power system. Don't want to push it to hard till I get use to flying it
and get it all trimmed in.
I will be replacing the stock motor mount for this one....Motor Mount w/Screws: FunJet ULTRA
The metal mount will be much stronger and also act as a heat sink for the motor.
Here are a few pics of my parts..
Last edited: