My GPS and AR7010 arrived yesterday and last nite I was reconnecting the naza to the rx the same as it was connected to the AR610E that did not have a preset failsafe.
A to Ale
T to Throddle
R to Rudder
E to Elev
U should be pulgged into the gear channel on my rx to make a 3 psoition switch correct? The 3 position switch would be the switch that controls the idle up 1 and 2. The would become the GPS/Att/Man switch. Now how do I make the other switches work I still have the aux 1 and aux 2 empty. I have not connected the GPS yet still need to get the rx connected and the failsafe setup and my tx is a DX7. I sure could use some help here guys.
Thanks
A to Ale
T to Throddle
R to Rudder
E to Elev
U should be pulgged into the gear channel on my rx to make a 3 psoition switch correct? The 3 position switch would be the switch that controls the idle up 1 and 2. The would become the GPS/Att/Man switch. Now how do I make the other switches work I still have the aux 1 and aux 2 empty. I have not connected the GPS yet still need to get the rx connected and the failsafe setup and my tx is a DX7. I sure could use some help here guys.
Thanks