Misc. Digital Programmable Servos

Fly-n-Low

Active Member
So you can center them, over load protection.... high resolution settings?

What else?

Fixing to build a 3D plane. Probably going to use a programmable RX, unless a conflict?

Head spinning... remembering the old analog days when expo was a pot!!!! LOL!
 

Smoggie

Well-Known Member
You can adjust travel (higher or lower). You can adjust speed (slower).

To be honest 99% of the time default is fine and programming isn’t necessary
 

Smoggie

Well-Known Member
Thanks. I was kind of wondering why the redundancy. As you can do most of that with a RX or TX.

exactly, I’ve not so far found any real advantage to programming the servo compared to adjusting in the Tx. The end result is the same in most cases. This probably explains why few manufacturers have gone down the programmable route
 
Top Bottom