Tony
Staff member
Hello everyone. I created this out of necessity as they shorted me about 6 of them in a kit. Instead of buying more, I figured I would just create and print them.
These are the nuts that you screw into to secure full size servos to 600+ size helicopters. The hole spacing is 10mm which is center to center spacing of a full size servo.
Here is the direct link to the Tinkercad file: 3D design 600_Servo_Nut | Tinkercad
STL is below
These are the nuts that you screw into to secure full size servos to 600+ size helicopters. The hole spacing is 10mm which is center to center spacing of a full size servo.
Here is the direct link to the Tinkercad file: 3D design 600_Servo_Nut | Tinkercad
STL is below