marcus621000
New Member
Hello all
Will be starting a build on Qav500,if i could get some suggestions on motor and esc choices it would be fantastic,as i am totaly confused as to what to run,Fpv manuals suggest a few motor combos,the ones i would like to get are.
Tiger MT4006
They suggest 18amp esc with simonk firmware.
My Question is i will be using a full pay load eventually being naza flight,and gps,5000 4s battery,fpv system,etc,will these motors and escs have any trouble with the weight,i would rather spend the money now for good quality motors and escs than find out latter i need bigger ones.
the height of escs aparantly cannot be over 11mm in height. 18 amps seems a little low to me
Is it better to run 14.8 volts or 11.1.
Any advise would of great help thanks.
Regards mark.
Will be starting a build on Qav500,if i could get some suggestions on motor and esc choices it would be fantastic,as i am totaly confused as to what to run,Fpv manuals suggest a few motor combos,the ones i would like to get are.
Tiger MT4006
They suggest 18amp esc with simonk firmware.
My Question is i will be using a full pay load eventually being naza flight,and gps,5000 4s battery,fpv system,etc,will these motors and escs have any trouble with the weight,i would rather spend the money now for good quality motors and escs than find out latter i need bigger ones.
the height of escs aparantly cannot be over 11mm in height. 18 amps seems a little low to me
Is it better to run 14.8 volts or 11.1.
Any advise would of great help thanks.
Regards mark.