Grant Ridgley
Member
Good evening everyone,
I have just received a new Omnibus F4 Betaflight 3.2.0 Osd Stm32f405rgt6 Flight Controller.
I am hoping to combine this with a Flysky FS-IA6B receiver to use to link my Flysky transmitter to a simulator via Betaflight.
Being very new to the RC game I would like some direction as to where I solder the receiver wires to the board. From what I can see there is only a single PPM label, but there are paired holes and labels. RX1 is the inner label and PPM the outer near the edge of the board. Is the PPM hole the one near the edge of the board and are the ground and 5V the holes immediately adjacent to this the ones I solder the extra wires to.
Any advice would be really appreciated.
cheers
Grant
I have just received a new Omnibus F4 Betaflight 3.2.0 Osd Stm32f405rgt6 Flight Controller.
I am hoping to combine this with a Flysky FS-IA6B receiver to use to link my Flysky transmitter to a simulator via Betaflight.
Being very new to the RC game I would like some direction as to where I solder the receiver wires to the board. From what I can see there is only a single PPM label, but there are paired holes and labels. RX1 is the inner label and PPM the outer near the edge of the board. Is the PPM hole the one near the edge of the board and are the ground and 5V the holes immediately adjacent to this the ones I solder the extra wires to.
Any advice would be really appreciated.
cheers
Grant