I built this quad I found listed on utube using the plush30A esp. I assembled it with no issues & purchased a DX6 to control it. When I went to fire it up only 3 motors ran correctly & the 4th started slow & then quit. If I turn the motor by hand it will run for a second 'again at a slow rate' & then quit. I switched the esp's around & I get the same result with the same esp no matter where I set it up. Am I missing something I need to adjust with this one esp or is it just bad? Below is a list of the parts I used to build the quad.
Thank you for any help, this is my first quad build so I am a in the dark on this all thought I have a lot of experience racing RC trucks & cars so I do have some what of a clue (I think).
- - - Updated - - -
Parts
SK450 - FRAME
ATMEGA168A - control board
hobby king power distribution board
NTM PROP DRIVE SERIES 26-28a 1200KV - motors
Thank you for any help, this is my first quad build so I am a in the dark on this all thought I have a lot of experience racing RC trucks & cars so I do have some what of a clue (I think).
- - - Updated - - -
Parts
SK450 - FRAME
ATMEGA168A - control board
hobby king power distribution board
NTM PROP DRIVE SERIES 26-28a 1200KV - motors