I'm building a TREX 470LM. All servos set so the horn is at 90deg to the servo. At no throttle, when I push the elevator stick forward , the elevator horn comes close to the top 'main shaft bearing block', but doesn't hit. At half throttle and up, the elevator horn is almost touching the block and if I push the elevator stick forward a tiny bit, the horn touches the block and starts to bind.
I've checked the build and can't figure out what I've done wrong.
A friend of mine suggested that I swap out the microbeast flybarless system that the kit comes with, with an IKON2 system from the get go. I did this. Could that be tied to my problem?
I've checked the build and can't figure out what I've done wrong.
A friend of mine suggested that I swap out the microbeast flybarless system that the kit comes with, with an IKON2 system from the get go. I did this. Could that be tied to my problem?