Hi, can anyone please help. I purchased two micro zone mc6c transmitters and receivers sets new last week. Today I fitted the receiver and not much is happening. At start up I get movement in the rudder servo as power hits it for the first time. The receiver led is flashing orange, but I am getting no movement from the controls. All have new batteries fitted. Not one of the sets works.
some one as stated that maybe they need binding, but there is no manual or any information and no binding cable included. I have looked all over the net for information but have been unable to find any. So before I send them back, I just want too make sure that I am doing nothing wrong. Can anyone put some light on this if they have found away to make these transmitters work. Thanks
some one as stated that maybe they need binding, but there is no manual or any information and no binding cable included. I have looked all over the net for information but have been unable to find any. So before I send them back, I just want too make sure that I am doing nothing wrong. Can anyone put some light on this if they have found away to make these transmitters work. Thanks
