exctmt
New Member
I am working on my first laser cut balsa kit. Ready to set up the servo linkage to the tail and rudder.
Ailerons are not a problem. The kit came with adjustable clevis ends for those.
But it came with "stoppers" for the servos to the rudder and tail.
If I install the "stopper" on the servo arm using the small threaded stud and pass the push - pull rod through the hole and tighten it with the set screw it becomes solid.
It will not swivel to accommodate the action of the servo. ???
What am I doing wrong?
The instruction manual is vague at best.
I am attaching some pictures, from the manual that they use to illustrate installation.
Also, the parts they include in the kit.
And some pictures from my plane.
Thanks for any help.
Ailerons are not a problem. The kit came with adjustable clevis ends for those.
But it came with "stoppers" for the servos to the rudder and tail.
If I install the "stopper" on the servo arm using the small threaded stud and pass the push - pull rod through the hole and tighten it with the set screw it becomes solid.
It will not swivel to accommodate the action of the servo. ???
What am I doing wrong?
The instruction manual is vague at best.
I am attaching some pictures, from the manual that they use to illustrate installation.
Also, the parts they include in the kit.
And some pictures from my plane.
Thanks for any help.