Hello to all of you.
If anyone can help, please i need your support in two issues.
Well, i enter 3gx dir mode. I have done all my mechanical setups nearly perfect (perfectly level swash, 90° servo arms at mid stick, 0° pitch at mid stick, same servo links length etc). During this stage of dir mode, i use pitch and throttle curve straight line under normal flight mode 0,25,50,75,100.
So, here i face up two difficulties and don't know how to solve.
1. When i move my swash all the way up and down travel, i read +7.2° and - 7° accordingly. How do i reach the recommended +11° and - 11°? By adjusting end points (as i understand in 3gx) it's not allowed, so i let them as they are (100%). To play with swash AFR Pit value (again as i understand) it's not for present moment. It is to adjust in continuing steps after dir mode. In any case i try once there, i adjust AFR Pit value and reach uper swash at 11° but when i pull swash far down it shows again - 7°.
So how the heck to adjust the travel limits?
2. My second issue is that the swash in the upper position, has a very small gap with elevetor servo link. How to eliminate this? Mechanical.... Hm i don't think so, because linkages are equal!
That's all. Many thanks for your time and also thanks in advance for any input.
Regards Dim
If anyone can help, please i need your support in two issues.
Well, i enter 3gx dir mode. I have done all my mechanical setups nearly perfect (perfectly level swash, 90° servo arms at mid stick, 0° pitch at mid stick, same servo links length etc). During this stage of dir mode, i use pitch and throttle curve straight line under normal flight mode 0,25,50,75,100.
So, here i face up two difficulties and don't know how to solve.
1. When i move my swash all the way up and down travel, i read +7.2° and - 7° accordingly. How do i reach the recommended +11° and - 11°? By adjusting end points (as i understand in 3gx) it's not allowed, so i let them as they are (100%). To play with swash AFR Pit value (again as i understand) it's not for present moment. It is to adjust in continuing steps after dir mode. In any case i try once there, i adjust AFR Pit value and reach uper swash at 11° but when i pull swash far down it shows again - 7°.
So how the heck to adjust the travel limits?
2. My second issue is that the swash in the upper position, has a very small gap with elevetor servo link. How to eliminate this? Mechanical.... Hm i don't think so, because linkages are equal!
That's all. Many thanks for your time and also thanks in advance for any input.
Regards Dim