Trucks T-Maxx Pro 15

[Tony]

Bearings will never seal 100%. If you are having abnormal idling or lean issues, then look at replacing the front bearing. Otherwise, it's likely fine. All front bearings will leak just a bit. But excessive should be replaced.

 

[Brandon Parker]

 

[Brandon Parker]

Bearings will never seal 100%. If you are having abnormal idling or lean issues, then look at replacing the front bearing. Otherwise, it's likely fine. All front bearings will leak just a bit. But excessive should be replaced.

was a tiny puddle under the flywheel

 

[Tony]

If you know how to replace the front bearing, I say go for it. And definitely need a new clutch spring.

 

[Brandon Parker]

If you know how to replace the front bearing, I say go for it. And definitely need a new clutch spring.

going to replace the bearings .already tore the motor down to the engine block
and by the way your videos are very helpful

 

[Tony]

Thank you. I do not have a bearing replacement though as it does require a lot of heat to release the bearings. You will need to heat the case up to about 150-200ºF to remove the bearings. Do not try to remove them cold, you will destroy the engine block.

 

[Brandon Parker]

Thank you. I do not have a bearing replacement though as it does require a lot of heat to release the bearings. You will need to heat the case up to about 150-200ºF to remove the bearings. Do not try to remove them cold, you will destroy the engine block.

yep I know how to remove the bearings watched your video and already done it once
were you explain how to do it.and the engine block breaks if you thought it was your fault lol

 

[Brandon Parker]

i
just ordered my bearings for my engine from fasteddybearings Traxxas TRX Pro .15 Sealed Bearing Kit

 

[Brandon Parker]

the rear bearing will not come out after Heating

 

[Brandon Parker]

the rear bearing finally came out after reheating and tapping on The Cutting Board

 

[Brandon Parker]

T-Maxx engine stalls outat mid-to-high throttle and wheels are off the ground is not engine stalls out

 

[Brandon Parker]

the engine is still stalling out to mid-to-high range throttle .it might be the clutch shoe and spring
or might be feel a line and pressure line have hole

 

[D.O.G.]

That's why the next RC truck I purchased was an electric one. Nitro is nice but to much headache for me anyway .

 

[Ronaldshirk]

Sorry bro Brandon Parker

 

[Brandon Parker]

Sorry bro Brandon Parker

just trying to figure out what is causing the issue