When installing the pinion gear on the motor shaft the grub screw needs to be set on the flat spot of the shaft. I have set this grub screw at eth bottom of the flat spot on the shaft.
Consequently, the pinion gear does not go down as far as pictured in the manual (pic attached).
Any suggestions?
![Motor Pinion.jpg Motor Pinion.jpg](https://www.rc-help.com/data/attachments/6/6043-4eac44f48df9dfef4a01f226bd772af2.jpg)
![Motor Pinion.jpg Motor Pinion.jpg](https://www.rc-help.com/data/attachments/6/6044-57929901654da87f80d7a1e43d5864da.jpg)
![Pinion mesh 1.jpg Pinion mesh 1.jpg](https://www.rc-help.com/data/attachments/6/6045-489171edf0d87641b8fd2fe51bc47e8b.jpg)
![Pinion Mesh 2.jpg Pinion Mesh 2.jpg](https://www.rc-help.com/data/attachments/6/6046-abe322280d7da79a4612e0383bf00f37.jpg)
Consequently, the pinion gear does not go down as far as pictured in the manual (pic attached).
Any suggestions?
![Motor Pinion.jpg Motor Pinion.jpg](https://www.rc-help.com/data/attachments/6/6043-4eac44f48df9dfef4a01f226bd772af2.jpg)
![Motor Pinion.jpg Motor Pinion.jpg](https://www.rc-help.com/data/attachments/6/6044-57929901654da87f80d7a1e43d5864da.jpg)
![Pinion mesh 1.jpg Pinion mesh 1.jpg](https://www.rc-help.com/data/attachments/6/6045-489171edf0d87641b8fd2fe51bc47e8b.jpg)
![Pinion Mesh 2.jpg Pinion Mesh 2.jpg](https://www.rc-help.com/data/attachments/6/6046-abe322280d7da79a4612e0383bf00f37.jpg)
Last edited: