Mda1701d
Member
Hello all,
Went out for my first proper flight yesterday, but ended in frustration. Not changed any settings since last weeks succesfull spool up and hover/hopping tests, but now i have problems. The heli wont spool up without trying to spin round on the ground, on the grass it tried to tip it was that bad. I thought the training gear might be affecting it, so took it off, and went through the tail set up again on the 3gx (version 4)
I noticed the tail servo wasnt centering again and the end limits were difficult to set, but i think i got it fairly close. Tried spooling again, but even at very low throttle, the heli tried to spin, and wthout the training gear, it went over. Looks like the only damage was a chip out of the paint on one blade, lucky.
Has anyone else had trouble setting up the tail on dominators? I know theres alot of posts about tail wag, but last week mine was solid! Any ideas would be helpfull, so i can get this thing in the air! Thanks all.
Went out for my first proper flight yesterday, but ended in frustration. Not changed any settings since last weeks succesfull spool up and hover/hopping tests, but now i have problems. The heli wont spool up without trying to spin round on the ground, on the grass it tried to tip it was that bad. I thought the training gear might be affecting it, so took it off, and went through the tail set up again on the 3gx (version 4)
I noticed the tail servo wasnt centering again and the end limits were difficult to set, but i think i got it fairly close. Tried spooling again, but even at very low throttle, the heli tried to spin, and wthout the training gear, it went over. Looks like the only damage was a chip out of the paint on one blade, lucky.
Has anyone else had trouble setting up the tail on dominators? I know theres alot of posts about tail wag, but last week mine was solid! Any ideas would be helpfull, so i can get this thing in the air! Thanks all.
