FBL Gyro BeastX and satellite

[fran11784]

Never hurts to ask so here goes. I've probably done this 100 times but this one I can't figure. Setting up a Microbeast with attitude control for a buddy. Flashed the upgrade to the controller no problem. Now when I try to rebind the controller and the Spektrum satellite, the LED on the controller flashes but the sat does nothing. Now I am quite familiar with these buggers. I believe I have tried everything I know but can't get the sat to blink. This is a BeastX plus not an ultra. Anyone ever run into such a thing? Thanks, T

 

[fran11784]

In case any one ever runs into this what I did is flash back to the firmware before and was able to bind it. Not sure what was up but I tried everything. Maybe a glitch in the update…

 

[Geena]

That is odd. There must have been a bug or error in the firmware. I`m glad you got it sorted.

 

[fran11784]

LMAO, was sent this by the BeastX folks. Take a look at number two.

5.9.9

• fix for Standard receiver wiring
• initiate DSMX bind by pressing button long during init sequence
• fix for throttle channel not working in BASIC edition
• fix for governor sensor not recognized

Telemetry/PROEDITION

• removed "Flightpack B" data from Spektrum SRXL2 telemetry
• Kontronik Jive PRO/Kosmik capacity (mAh) by factor 10 too high.

 

[James M. Lewis]

Hi Geena, Tony aka fran11784 has set up my Dominator Trex 450L Top with above data. Been out of the loop for a while due to health issue's, but I'm back at full throttle

 

[D.O.G.]

Good to see that your back in action