My esc on a 500dfc trex went up in smoke and I upgraded to the castle talon 90. My problem is after going through the talon setup using the castle link and software I am unable to get a response to my heli. Initialization never happens, meaning I do not see the servos move prior to flying. I see the satellites all lit but nothing else happens. Am I not doing another step to allow the 3gx to go through its initialization. Somewhere I read that I need to program the throttle end points for the esc but not sure how to do this. Do I need to rebind the receiver and 3gx? I am using 2 sats with a spectrum ar9020 and a telemetry Tm1000 unit.