Derek
Well-Known Member
I've had a spare Naze32 rev 5 just laying around and I decided to put it on my little Delta Wing, made from a single sheet of Dollar Tree foamboard. I've gotten it all set up and working properly, with the exception of one thing. The servo travel is pathetic. In Cleanflight, it says to adjust the Servo Travel in the tx to a high and low of 1000 - 2000, with 1500 in the middle. I've done that. When I give full elevator, up or down, the servos move the control surfaces very very little. The same thing with full left or right Aileron.
Now, I've flown this type of Delta Wing without a stabilizer of any sort and I can make the servos move so much that the control surfaces are 45 degree up and down. But then I connect the Naze32 and the control surface travel is very little.
Any ideas or suggestions???
Now, I've flown this type of Delta Wing without a stabilizer of any sort and I can make the servos move so much that the control surfaces are 45 degree up and down. But then I connect the Naze32 and the control surface travel is very little.
Any ideas or suggestions???