stokke
Well-Known Member
So I'm about to mount the motor on my Agile. But if you look at the picture below, the leads are pointing downward, but I will need them to point upwards. After examining the leads I can conclude that they are not leads at all, but the end of the motor windings sticking out. Is it safe to bend these?
I tried flexing them and they seem to be soft enough to bend all the way, but could there be a chance they might get damaged?
Also, I'm not sure how to go about soldering these wind-ends. I doesn't seem like a good idea to solder bullets directly onto these, so I thought I might solder on some wires/leads. Do I lay the leads flat on the windings and just solder? Do I braid it on before soldering?
Ideas?
Suggestions?
Facts?
I tried flexing them and they seem to be soft enough to bend all the way, but could there be a chance they might get damaged?
Also, I'm not sure how to go about soldering these wind-ends. I doesn't seem like a good idea to solder bullets directly onto these, so I thought I might solder on some wires/leads. Do I lay the leads flat on the windings and just solder? Do I braid it on before soldering?
Ideas?
Suggestions?
Facts?