Trucks I play with my T-Maxx

[bigone5500]

Please refer to Tony's video here:

 

[Tony]

You need to center up your servo and set your toe-in. And make sure your drive hexes on the inside of the wheels are not stripped out.

 

[bigone5500]

If the hexes are not stripped, not having the pin behind the hex can also make it pull.

 

[Brandon Parker]

Yes I know about the videos I've watched that video about 3 to 4 times thanks

 

[bigone5500]

I hope you get it figured out Brandon. These things are a blast to drive around.

 

[Brandon Parker]

The front turnbuckles have to be adjusted Evelyn right

 

[Tony]

Yes, with the servo centered, each front wheel needs to have the exact same toe in.

 

[Brandon Parker]

Replace front and rear bulkheads the front bulkheads where cut they are reruns

 

[Tony]

Replace front and rear bulkheads the front bulkheads where cut they are reruns

I have no idea what this means...

 

[Brandon Parker]

Here is a picture of the front bulkhead see what I mean it's labeled back bulkheads that's what it says on the plastic

 

[Brandon Parker]

Here is a picture of the front bulkhead see what I mean it's labeled back bulkheads that's what it says on the plastic

 

[Brandon Parker]

I have no idea what this means...

Meant to say replace front and rear bulkheads because the front bulkheads have been cut

 

[Brandon Parker]

Need some help with steering need help with steering not coming back to Centerpoint

 

[Tony]

9 times out of 10, you are going to need a stronger servo. These trucks have very large wheels and it takes a lot of torque to turn them.

 

[Brandon Parker]

Both Wheels towed out what caused it

 

[Tony]

you need to toe them in with the steering rods.

 

[Brandon Parker]

So go ahead on it right now so high torque

 

[Brandon Parker]

The servo is a high-torque

 

[Tony]

If it's not centering, then either it's not high enough torque, your servo saver is worn out or the servo is just flat worn out.

 

[Brandon Parker]

Took the servo Saver off the linkage I connected it straight to the servo and tried it not not come back to Center going to replace a servo and Servo saver