You are talking about nowhere to keep it right now it sits on the kitchen counter

don't know for how long maybe until it get put in the trash or I get in the trash will see who goes first.

. Oh, when I have to work on it it goes to the kitchen table, now how do you thing that goes. Actually, this is just man BS, what others expect to hear. My wife has not said anything, wait a minute, silent treatment, I better find a new place soon.
This is the history so far;
I got this heli Trex 700L used, I have no problem with that. The first time I took it for a hover the spooling up was good, as I increased the collective all of the sudden the tail stopped spinning, the heli never moved, so I knew the tail did not hit the ground. After inspecting I found the two front 45deg gears stripped, the drive gear was perfect no damage. Now this puzzled me because these gear's meshing is set by the gear housing nothing we can do about it. I manually spin the shaft and felt smooth. I replaced the gears, put it back together and ran it without blades, all was okay.
Tuesday took it for a hover and everything looked good other then a drift to the right . Wednesday I adjusted for the drift and went out to try to hover when again the tail gears stripped but this time was the rear two 45 deg by the blade and the two front are bad as well. The drive gear is good and same scenario as I increased the collective all of the sudden the tail stopped spinning, Heli never left the ground or moved.
Have not taken it apart again because I don't have replacement gears, received email today that they shipped. Any suggestion of what to look will be appreciated. I have been told to check the governor gain setting in the Castle EDGE HV160 if it is to high could cause this. It was set to 20 I lowered it to 14 will see what happen once I fix it.