heli_aviator
New Member
I need some help... I purchased a TREX 250 PRO Super Combo (with fly bar). It came with an ALIGN GP790 gyro. and 4 servos (3 ALIGN DS410 and 1 ALIGN DS420). The DS420 servo is for the tail rotor and it's suppose to be located just under the where the tail boom enters the airframe. (not on the boom). I know this servo goes into the gyro and the gyro is plugged in the rudder slot. with the gain lead going into the gear slot (rx does not have an Aux 2).
I also purchased a Spectrum AR600 6 channel receiver. with the following slots: AUX1, GEAR, RUDD, ELEV, AILE,THRO and BIND/DATA.
This is my first attemp at building a helicopter and I need help. I know where the servos go on the airframe, but I don't know the name of each servo that connects to the 3 points on the swash plate. . there are 2 servos stacked in front of main rotor shaft on the airframe. One on the left (lower) and one on the right (upper). A third servo is located just aft of the main rotor shaft on the left. The assembly manual does not point out the name of each servo . It does however, indicate where each servo goes in the RX. Can someone tell me the name of the left, right and aft connecting points on the swashplate (ie evlevator/pitch, aileron, etc.)?
Thank you
heli_avaitor... aka Mel
Long Beach, CA
I also purchased a Spectrum AR600 6 channel receiver. with the following slots: AUX1, GEAR, RUDD, ELEV, AILE,THRO and BIND/DATA.
This is my first attemp at building a helicopter and I need help. I know where the servos go on the airframe, but I don't know the name of each servo that connects to the 3 points on the swash plate. . there are 2 servos stacked in front of main rotor shaft on the airframe. One on the left (lower) and one on the right (upper). A third servo is located just aft of the main rotor shaft on the left. The assembly manual does not point out the name of each servo . It does however, indicate where each servo goes in the RX. Can someone tell me the name of the left, right and aft connecting points on the swashplate (ie evlevator/pitch, aileron, etc.)?
Thank you
heli_avaitor... aka Mel
Long Beach, CA