Tony
Staff member
As for the servos, are you saying that they are twitching all the time, or just when the motor is full throttle?
For the motor, it sounds like you need to set the endpoints in the ESC so it knows where your high and low throttle is set at. Below is a link to the manual and on page 3, this should be how you set it. You can also turn the brake on or off depending on what you want. With a plane, I turn the brake on.
http://manuals.hobbico.com/gpm/gpmm1800-1841-manual-v1_2.pdf
And yes, you are going to want to run a 3s pack on this plane. It was designed to run a 2200mah 3s pack, and I would suggest at least a 35c just to be safe.
For the motor, it sounds like you need to set the endpoints in the ESC so it knows where your high and low throttle is set at. Below is a link to the manual and on page 3, this should be how you set it. You can also turn the brake on or off depending on what you want. With a plane, I turn the brake on.
http://manuals.hobbico.com/gpm/gpmm1800-1841-manual-v1_2.pdf
And yes, you are going to want to run a 3s pack on this plane. It was designed to run a 2200mah 3s pack, and I would suggest at least a 35c just to be safe.